PDA

View Full Version : BUILT 2.8 S-10 engine***ALL SOLD***


MisterX
09-22-2007, 03:53 PM
1986 2.8 TBI engine, tranny, and transfer case from S-10. Motor was rebuilt by Don's Performance in Fredericton, and has about 12,000 kms on it. It comes with an upgraded ECU, original ECU with aJET chip, and Hypertech stage 2 chip. It is bored .040" over with Sealed Power Hypereutectic flat top pistons, Crane Compu-Cam, Comp Camps roller tipped rockers with 1.52:1 ratio, rebuilt heads, custom oversize TBI and matching intake. Crankshaft was turned down with all new bearings from Clevite. Also has Centreforce clutch and Heddman headers. It has a guestimated 170 hp and about 200 foot pounds of torque. It is currently out of the vehicle, but I will guarantee this engine runs.....and runs well!! $600 o.b.o. will accept stereo equipment as partial trade.***ALL SOLD***

MisterX
10-13-2007, 11:10 PM
Make an offer.....ANY OFFER....trades.....whatever....I need space in my garage!!!

scotty_22
10-15-2007, 06:50 PM
hey, i am intyerested, but only in the motor. but not the tranny and transfer case, my truick is a 2wd. I was wondering why you have it out of your truck? was it in a daily driver? you can email me with any info at scott_2_@hotmail.com thanks.

MisterX
10-18-2007, 08:01 PM
Still have this, and found LOTS of extra injectors, sensors, fuel pumps, sending units, skid plates, Y-pipe, code reader, and more....all to go with this!

MisterX
10-20-2007, 11:45 AM
an Auburn Gear limited slip differential is available too.......cheap with engine purchase!

MisterX
10-21-2007, 04:07 PM
****all Sold****